EasyManuals Logo

McCulloch CS 42S User Manual

McCulloch CS 42S
536 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
3. 3XOORIIWKHVSDUNSOXJERRW&
4. 5HPRYHVSDUNSOXJ'IURPWKHF\OLQGHUDQG
discard.
5. Install a new spark plug and tighten securely with
DPPLQFKVRFNHWZUHQFKWR1P
IWOE7KHVSDUNSOXJJDSVKRXOGEHPP
LQFK
6. Reinstall the spark plug boot.
7. Reinstall the cylinder cover and the three screws.
7LJKWHQVHFXUHO\WR1PLQOE
CARBURETTOR ADJUSTMENT
a WARNING: The chain will be moving
during most of this procedure. Wear your
protective equipment and observe all safety
precautions. The chain must not move at idle
speed.
Indications for idle speed adjustment
The carburetor has been carefully set at the factory.
Adjustments may be necessary if you notice any of the
following conditions:
The chain moves at idle. See IDLE SPEED-T
ADJUSTMENT procedure.
The saw will not idle. See IDLE SPEED-T
ADJUSTMENT procedure.
Idle speed-T adjustment
Allow the engine to idle. If the chain moves, the idle is
too fast. If the engine stalls, the idle is too slow.
Adjust the speed until the engine runs without chain
PRYHPHQWLGOHWRRIDVWRUVWDOOLQJLGOHWRRVORZ
The idle speed screw is located in the area above the
SULPHUDLUSXUJHEXOEDQGLVODEHOHG³7´
7XUQWKHLGOHVSHHGVFUHZ7FORFNZLVHWRLQFUHDVH
the engine speed.
7XUQWKHLGOHVSHHGVFUHZ7FRXQWHUFORFNZLVHWR
decrease the engine speed.
COOLING SYSTEM
To keep the working temperature as low as possible
WKHPDFKLQHLVHTXLSSHGZLWKDFRROLQJV\VWHP
The cooling system consists of:
Air intake on the starter
Air guide plate
)LQVRQWKHÀ\ZKHHO
&RROLQJ¿QVRQWKHF\OLQGHU
&\OLQGHUFRYHUGLUHFWVFROGDLURYHUWKHF\OLQGHU
Clean the cooling system with a brush after each use,
more often in demanding conditions. A dirty or blocked
cooling system results in the machine overheating
which causes damage to the piston and cylinder.
16

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the McCulloch CS 42S and is the answer not in the manual?

McCulloch CS 42S Specifications

General IconGeneral
Chain gauge1.3 mm
Chain pitch3/8 \
Chain speed20 m/s
Product colorBlack, Yellow
Oil tank capacity0.2 L
Fuel tank capacity0.3 L
Engine displacement42 cm³
Noise level115 dB
Power sourceGasoline
Weight and Dimensions IconWeight and Dimensions
Weight4900 g

Related product manuals