16
How to Connect Audio and Digital Components
McIntosh MVP841 DVD Player
How to Connect Audio and Digital Components
The MHT100 accepts Analog Audio and Digital Audio
Signal Inputs. It is important to connect the Analog Outputs
along with the Digital Audio Signal Output from source
components connected to the MHT100. This will assure
that the audio from that source component is available to
the VCR1 and 2 Outputs and Zone B.
Note: If MHT100 does not have the Tuner Module installed
an external Tuner may be connected.
1. Connect a cable from the MHT100 DIGITAL Coaxial
DVD INPUT (Input E/5) to the McIntosh Coaxial
Digital Output of the MVP841 DVD Player.
2. Connect a cable from the MHT100 AUDIO INPUTs
DVD to the McIntosh Audio Outputs of the MVP841
DVD Player.
3. Connect a cable from the MHT100 SAT Optical DIGI-
TAL INPUT (Input C) to the Optical Digital output of a
Satellite Receiver.
4. Connect a cable from the MHT100 Audio SAT INPUTs
to the Audio Outputs of the Satellite Receiver.
5. Connect a cable from the MHT100 VCR1 Audio OUT-
PUT to the VCR Audio Input.
6. Connect a cable from the MHT100 VCR1 Audio IN-
PUT to the VCR Audio Output.
7. Connect a cable from the MHT100 CD INPUT Optical
DIGITAL INPUT (Input B) to the Optical Digital Out-
put of the DVD-Audio/SAC Disk Player.
8. Connect cables from the MHT100 EIGHT CHANNEL
Audio INPUTs to the DVD-Audio/SAC Disk Player
Audio Outputs.
9. Connect a cable from the MHT100 ZONE A
SUBwoofer PREAMP OUTPUT to the McIntosh Pow-
ered Subwoofer Line In jack.
Satellite Receiver
DVD-Audio/SAC Player
McIntosh Powered Subwoofer
In Out VCR
To Next Page
Loading...
Need help?
General