9
Installation
The MHT100 can be placed upright on a table or shelf,
standing on its four feet. It also can be custom installed in a
piece of furniture or cabinet of your choice. The four feet
may be removed from the bottom of the MHT100 when it
is custom installed as outlined below. The four feet to-
gether with the mounting screws should be retained for
possible future use if the MHT100 is removed from the
custom installation and used free standing. The required
panel cutout, ventila-
tion cutout and unit
dimensions are
shown.
Always provide
adequate ventilation
for your MHT100.
Cool operation en-
sures the longest pos-
sible operating life for
any electronic instru-
ment. Do not install
the MHT100 directly
above a heat generat-
ing component such
as a high powered am-
plifier. If all the com-
ponents are installed
in a single cabinet, a
quiet running ventila-
tion fan can be a defi-
nite asset in maintain-
ing all the system
components at the
coolest possible oper-
ating temperature.
A custom cabinet
installation should
provide the following
minimum spacing di-
mensions for cool op-
eration. Allow at least
4 inches (10.16cm)
above the top, 2
inches (5.08cm) be-
low the bottom and
1 inch (2.54cm) on
each side of the A/V
System Controller, so
Installation
8-5/16"
21.11cm
17-1/16"
43.34cm
MHT100 Front Panel
Custom Cabinet Cutout
Cutout
Opening
for
Ventilation
Cutout Opening for Ventilation
Support
Shelf
Cabinet
Front
Panel
Chassis
Spacers
MHT100 Side View
in Custom Cabinet
MHT100 Bottom View
in Custom Cabinet
7"
17.78cm
14-1/2"
36.83cm
15"
38.1cm
14-1/16"
35.71cm
2-1/2"
6.35cm
Cutout Opening
for
Custom Mounting
6"
15.24cm
Opening
for Ventilation
1"
2.54cm
2"
5.08cm
12-1/2"
31.75cm
1-1/4"
3.18cm
that airflow is not obstructed. Allow 21 inches (53.34cm)
depth behind the front panel. Allow 1 inch (2.54cm) in
front of the mounting panel for knob clearance. Be sure to
cut out a ventilation hole in the mounting shelf according
to the dimensions in the drawing.
To Next Page
Loading...
Need help?
General