42
The INPUT Selector Switch together with the Zone B
Push-button allows the making of a recording from one
program source while listening to another. You can also lis-
ten (monitor) to the recorded signal off the tape, a fraction
of a second later, during recording when a
three head tape recorder is used. Refer to fig-
ure 38.
1. Press the ZONE B Push-button, the LED
above the button will illuminate. Refer to
figure 35.
2. Rotate INPUT Selector Switch until the
desired Input has been selected. Refer to
figures 36 and 37.
Note: The INPUT Selector Switch will
return to ZONE A Input Selection,
about five seconds after the
ZONE B Push-button is pressed
and the INPUT Selector is no-
longer being rotated.
3. Adjust the record level using the
recorder’s volume control.
How To Make A Recording
Figure 38
Figure 36
Figure 35
4. To monitor the tape during recording with a three head
tape recorder, or playback the tape just recorded, turn
the INPUT Selector Switch to select the recorder used.
Note: The MHT100 RECORD OUTPUTS are not affected by
the VOLUME control. To listen to a different program
source while recording, turn the INPUT Selector Switch
to the desired source. The recording process will not be
affected and will continue.
Figure 37
To Next Page
Loading...