EasyManuals Logo

McIntosh MHT100 User Manual

McIntosh MHT100
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
Frequency Response
STEREO Left and Right Loudspeakers:
+0 -0.5dB from 20Hz-20,000Hz
MUSIC 1-4 Left, Center, Right Loudspeakers:
+0 -0.5dB from 20Hz-20,000Hz
Large Surround Loudspeakers:
+0 -0.5dB from 20Hz-20,000Hz
PROLOGIC Left, Center, Right, Large Loudspeakers:
±0.5dB from 20Hz-20,000Hz
Large Surround Loudspeakers:
+1 -3dB from 20Hz-6.3kHz
Subwoofer
1and2
:
20Hz-140Hz
Dolby Digital, Left, Center, Right Large Loudspeakers:
DTS and ±0.5dB from 20Hz-20,000Hz
EXTERNAL Large Surround Loudspeakers:
INPUT ±0.5dB from 20Hz-20,000Hz
Subwoofer
1and2
:
20Hz-140Hz
Rated Output
2V for all channels
Input Impedance
22K ohms
Output Impedance
Less than 560 ohms for all channels
Maximum Output Voltage
8V
Total Harmonic Distortion
0.05% for all channels
Sensitivity
Analog Input: 100mV IHF
Dolby Level 200mV Input
External Input 200mV for 2.0V output
Signal To Noise Ratio
Greater than 90dB A weighted
Maximum Input Signal
Analog Input: 6Vrms
Tone Controls
±12dB from the flat setting
1
If any of the Channels have the Loudspeaker Setting of
Small, the subwoofer has a electronic low pass filter with
a corner frequency of 80Hz and a 24dB per Octave
rolloff in all modes except external.
2
The Frequency Response of the Subwoofer Channel is
also detemined by the Crossover Setting.
Preamplifier and Processor Specifications
Preamplifier and Processor Specifications

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the McIntosh MHT100 and is the answer not in the manual?

McIntosh MHT100 Specifications

General IconGeneral
BrandMcIntosh
ModelMHT100
CategoryNetwork Router
LanguageEnglish