“SE Series” Service and Parts ManualMarch 2017
Page XI
F
REE
-W
HEEL
C
ONFIGURATION
F
OR
W
INCHING
OR
T
OWING
RUNAWAY HAZARD!
AFTER RELEASING THE BRAKES THERE IS NOTHING TO STOP MACHINE
TRAVEL. MACHINE WILL ROLL FREELY ON SLOPES.
ALWAYS CHOCK THE WHEELS BEFORE MANUALLY RELEASING THE BRAKES.
Disengage Brakes before Towing or Winching
1930SE
1 Chock the wheels.
2 At the Ground Controls panel, turn the
Key Switch to the GROUND position.
3 At the Platform Controls, pull or turn the
red Emergency Stop button clockwise to
the on position.
4 At the Ground Controls panel, press the
Emergency Stop button.
5 Push the Brake Release Switch to the left
& Push Down and Hold The Lift/Lower
Switch to the Lower Position
Pull or turn the Red Emergency Stop button
clockwise to the ON position
at the ground
controls. An Alarm & Horn will sound,
signaling that the brakes have been released.
Resetting Brakes
Press the Emergency Stop button, then push the
Brake Release Switch to the right to reset the
brake.
2632SE, 3346SE, 4046SE, 4555SE
1 Chock the wheels.
2 Turn the Key Switch to the OFF position.
3 Pull or turn the red Emergency Stop
button clockwise to the on position at
both the ground and platform controls.
4 At the Ground Controls panel, press and
hold the Lift/Lower Switch to the DOWN
position, then turn on the Key Switch to
the GROUND position.
5 Hold the Lift/Lower Switch in this
position until a continuous alarm sounds,
signalling that the brake has been
released.
Resetting Brakes
Turn the Key Switch to the OFF position to reset the brake.
Push Switch
1
To Left
Reset
E-Stop
(pull out)
2
ART_5183
Push Down
1
& Hold
Turn to
Ground
2
ART_5029
The machine can be winched or towed short distances at speeds not to exceed:
1930SE .5 mph
2632SE, 3346SE, 4046SE, 4555SE 2.5 MPH (4 km/h)
Before towing or winching the machine, it is necessary to release the brakes. Reset the brakes after towing
or winching.
AND
To Next Page
Loading...
