“SE Series” Service and Parts Manual March 2017
Page 1-3
PRE-START INSPECTION CHECKLIST
P
RE
-S
TART
I
NSPECTION
C
HECKLIST
Items on this checklist should be inspected before each work shift.
A copy of this checklist is available in the notes section of this manual.
Photocopy the Pre-Start Inspection Checklist to keep record of this inspection.
30-D
AY
S
ERVICE
The 30 day maintenance procedure is a one-time procedure to be performed after the
first 30 days or 40 hours of usage. These procedures are also performed at later
intervals.
Maintaining the tires and wheels in good condition is essential to safe operation and
good performance. Tire and/or wheel failure could result in a machine tip-over.
Component damage may also result if problems are not discovered and repaired
quickly.
1. Check the tire surface and sidewalls for cuts, cracks and unusual wear.
2. Check each wheel for damage, bends and cracks.
3. Check each wheel bolt for proper torque (38 ft-lbs/51 Nm dry).
H
YDRAULIC
F
ILTER
& B
REATHER
C
AP
Replace the Hydraulic Filter element
after the first 30 days of machine use.
After that, replace the Breather Cap
Filter and Hydraulic Filter every 6
months or 300 hours (whichever
comes first).
If the machine is used in very dusty,
exceptionally hot or exceptionally cold
conditions, replace the Breather Cap
Filter and Hydraulic Filter every 3
months or 150 hours (whichever
comes first).
F
REQUENT
I
NSPECTION
C
HECKLIST
THIS CHECKLIST MUST BE USED AT 3-MONTH INTERVALS OR EVERY
150 HOURS OF MACHINE USE, WHICHEVER OCCURS FIRST. FAILURE TO
DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
Frequent Maintenance Inspections should be conducted by qualified service
technicians only. Photocopy the Frequent Inspection Checklist page from the
Operator’s Manual to keep record of this inspection. Keep inspections records up to
date. Record and report all discrepancies to your supervisor.
Perform all checks listed on Pre-Start Inspection, then proceed with the following
checks.
ART_5124
Hydraulic
Reservoir
Hydraulic
Filter
Controls
Tray
Breather Cap
To Next Page
Loading...
