Mec SE Series - Page 43

“SE Series” Service and Parts ManualMarch 2017
Page 2-4
FAULT CODES
FAULT DESCRIPTION
MODELS
32 Angle Sensor Fault
42
Platform Left Turn Switch
ON at power-up Message
43
46
Platform Joystick Enable
Switch ON at power-up
Fault
47
52
Drive forward coil fault
All Models
1. (Check the angle sensor and wiring,
the normal range of voltage output
is 1.9 - 3.8V
2. (Check the option code)
All Models
All Models
SOLUTIONS
All Models
1. (Wait several seconds when turn on
the lift)
2. (Check the joystick deadman switch))
All Models
1. (Check the joystick)
2. (Check the platform controller)
1. (Check the left steer button)
2. (Check the platform controller)
Platform Right Turn Switch
ON at power-up Message
1. (Check the right steer button)
2. (Check the platform controller)
Platform Joystick not in
neutral at power-up
Message
Not Used
All Models
(Check the forward solenoid and wiring)
(Check the option code)
53
Drive reverse coil fault
Not Used
All Models
(Check the backward solenoid and wiring)
(Check the option code)
54
Lift Up Coil Fault
All Models
(Check the lift solenoid and wiring)
55
Lift Down Coil Fault
All Models
(Check the down solenoid and wiring)
56
Right Turn Coil Fault
All Models
(Check the right steering
solenoid and wiring)
57
Left Turn Coil Fault
All Mo
dels
(Check the left steering
solenoid and wiring)
58
All Models
General Brake Coil Fault
1. (Check the brake module and wiring)
2. (Check brakes and wiring)
3. (Check the battery voltage)
59
Not Used
Parallel Coil Fault
to the Coil's terminals and make sure they
are tight. If so, check the coil itself to see
(Parallel Coil Fault: Check the connections
if it is open or shorted.)
60
Motor Controller Fault
All Models
(
Replace the ZAPI
controller)
(Only for ZAPI large electric)