Mec SE Series - Page 47

“SE Series” Service and Parts ManualMarch 2017
Page 2-8
FAULT CODES
FAULT DESCRIPTION
MODELS
82
Right Brake Coil Fault
1930SE Only
All Models
SOLUTIONS
1. (Check the right motor brake and wiring
2. (Check the brake module and wiring)
85
Brake release switch open Fault
1930SE Only
(Brake release switch open fault)
87
Brake release switch Fault
89 Drive Motor Field Open Fault
(Check the Field wires on motors and ZAPI
controller to see if it is open or shorted
- Only for ZAPI large electric)
90
All Models
Over 90% Load Warning
91
Left Drive Motor Field Short Fault
All Models
1. (Check the wiring on right drive motor
and brake.)
(Remark: To make sure the drive motor
is good before - change the ZAPI motor
controller, or the drive motor will be
damaged again.)
2. (Check the wires to right drive motor)
3. (Check the ZAPI controller and wiring)
83
Left Brake Coil Fault
1930SE Only
All Models
1. (Check the left motor brake and wiring
2. (Check the brake module and wiring)
1. (Check the wiring on left drive motor
and brake.)
(Remark: To make sure the drive motor
is good before - change th
e ZAPI motor
controller, or the drive motor will be
damaged again.)
2. (Check the wires to left drive motor)
3. (Check the ZAPI controller and wiring)
(Only in 0807 ZAPI)
86
Raised brake release Fault
1930SE Only
(Raised brake release fault)
(Only in 0807 ZAPI)
1930SE Only
(Raised release switch open fault)
(Only in 0807 ZAPI)
All Models
(Over 90% Load Warning:
Platform is gettin
g
close to its limit of
weight. Consider not adding more
load.)
(Check the Field w
ires on motors and ZAPI
controller to see if it is open or shorted
- Only for ZAPI large electric)