UK/ N. IRELAND HELPLINE 0871 37 61 020
REP. IRELAND HELPLINE 1-800-992508
(calls are charged at 7p per min from a standard landline, calls from mobiles could be higher)
-66-
Inserting the Express Card 54 DVB-T Tuner
Note
Remove the dummy card from the Express Card/54 Slot before
installation. Replace the card to protect contacts against dirt if the
Slot is not used.
1. After starting Windows
®
, slide the card carefully into the proper slot as far as
it goes. The Express Card 54 DVB-T tuner then rebounds by a few
millimetres and locks into place. Two short signals, confirming successful
installation, will sound if the Express Card 54 DVB-T tuner has been pushed
in completely.
2. Start the application for TV reception, in order to set up the Express Card 54
DVB-T tuner. A set-up assistant will guide you through the program.
Removing the Express Card 54 DVB-T Tuner
Remove the Express Card 54 DVB-T tuner in the following manner:
1. Disconnect all cables.
2. Press on the card slightly in the direction of the slot and then let go of it. The
Express Card 54 DVB-T tuner sticks out from the slot and can be removed.
Store it in a safe place.
Note
If the Express Card 54 DVB-T tuner remains in the device and is not in
use, move the on/off-switch to the left (the LED goes out). If you
want to use the Express Card 54 DVB-T tuner again, move the switch
to the right. The LED lights up.
Do not switch off the Express Card 54 DVB-T tuner if it is being used.
To Next Page
Loading...
