27
2.2.1 UPS Configuration
This page is to set the UPS configuration. Any wrong settings will cause
incorrect display values or disconnection between the UPS and NetAgent.
UPS Properties
UPS Communication Type
This section is to set up the communication interface of the UPS. (eg. Contact
Closure/RS232/3 phase etc.) Please refer to the UPS manual to set the correct
communication type. Any wrong settings will cause disconnection between the UPS
and NetAgent.
Number of Batteries, Battery Full Charge Voltage (V), Battery Exhausted
Charge Voltage (V)
Please refer to the UPS manual to set the value.
Date of last battery replacement (yyyy/mm/dd)
This section is to record the date when the UPS battery was last replaced.
UPS Recorded
UPS Data Log
This section is to set how often the UPS data should be logged.
Test UPS
Test UPS for every
This section is to schedule the UPS to test once a week or once every two weeks or
not to test
Test UPS on Weekday
This section is to set the UPS to test on a particular day of a week.
Length of UPS Testing ( hh:mm)
This section is to set the UPS to test at a certain time on the test day.
Warning Threshold Value
Time out of after lost of connection
This section is to set a period of time after which NetAgent will send a disconnection
warning message. This warning message will be sent after NetAgent has lost
contact with the UPS for the time specified.
Critical Loading (%)
This section is to set the UPS critical loading. (shown as %) NetAgent will send a
warning message when the UPS is overloaded.
Critical Temperature (C)
This section is to set the UPS critical internal temperature. NetAgent will send
warning messages when the UPS overheats.
Critical Capacity (%)
This section is to set the UPS critical battery capacity (shown as % )NetAgent will
send warning messages when UPS low battery occurs.
To Next Page
Loading...
Need help?
General
