MegaTec NetAgent II User Manual

34
2.2.4 SNMP
This page is to set NetAgent SNMP settings so it can be used by a NMS
( Network Management System). (Eg: SNMPView, SNMPView can be found
on the NetAgent Utility CD.)
MIB System
System Name
This section is to give a name to a NetAgent.
System Contact
This section is to give a name to the administrator.
System Location
This section is to set NetAgent location.
Access Control
Manager IP Address
This section is to set the IP address that the administrator can manage NetAgent
from. It is valid for up to 8 IP addresses. To manage NetAgent from any IP address,
enter *.*.*.* into Manager IP address.
Community
This section is to set a Community name for NMS. The community name has to be
as the same as the setting in NMS.
Permission
This section is to set authorities of administrators. Options are Read, Read/Write,
and No Access.
Description
This section is for an administrator to make notes.
Trap Notification
Receiver IP Address
This section is to set receivers IP address for receiving traps sent by NetAgent. It is
valid for up to 8 IP Addresses.
Community
This section is to set a Community name for NMS. The community name has to be
as the same as the setting in NMS.
Severity
This section is to set Trap receiver levels. There are three levels of Trap receiver :
• Information: To receive all traps.
• Warning: To receive only “warning” and “severe” traps.
• Severe: To receive only “severe” traps.
( Please refer to NMS manual for Trap levels.)
Accept
This section is to set to receive a trop or not.
Description
This section is for an administrator to make notes.
Event
This section is to select events for NetAgent to send traps. Clicking on Select will
open a Select Events List. Event Traps may be selected from this list. Events list is
below:

MegaTec NetAgent II Specifications

General

Brand	MegaTec
Model	NetAgent II
Category	Controller
Language	English