EasyManuals Logo

MegaTec NetAgent II User Manual

Default Icon
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
1
Chapter1. Introduction
Section1. Features
NetAgent is a new generation SNMP (Simple Network Management Protocol)
monitoring product. Not only could remote control the UPS and get the current
status of it, the NetAgent II –3Ports also could provide other functions, ex.
connect to Modem could make the monitoring possible when there is no
permanent connection to Internet. The NetAgent II – 3Ports could also been
used to connect to ‘NetFeeler Lite’, to get the temperature, humidity and water
conditions. To get the condition of Smoke detector, Gas detector, door and
window detector will also be possible.
This product is for “Contact Closure” and “RS232” interface UPS. The
communication protocol includes the Contact Closure, RS232[MegaTec],
RS232[Phoenixtec], SEC 2400, SEC 9600, Three Phase, Powerware, Smart
APC, EMERSON. And user could also provide their own protocol to build in.
NetAgent provides a simple and easy installation procedure. User only needs
to install the software of NetAgent CD on a Windows environment to configure
the IP address. All the other configurations could be accomplished in a Web
browser.
NetAgent also provides shutdown utility for different operating systems. It
could send out the shutdown command in different conditions. These
conditions include the AC power failure, Battery Low, Over Loading, Over
Temperature and scheduled shutdown. User could configure these conditions
to initiate a system shutdown event, and to avoid the abnormal power
disconnection of the system.
Features:
n Provide SNMP MIB to monitor & control UPS
o Auto-sense 10M/100M Fast Ethernet
p Manage and configure via Telnet, Web Browser or NMS
q Support TCP/IP, UDP, SNMP, Telnet, SNTP, PPP, HTTP, SMTP Protocol
r Providing easy setup and upgrade tools via MS-Windows, just a few
seconds to finish IP setting, about 1.5 minutes to upgrade firmware.
s Sending both of SNMP TRAP and E-mail for events notification.
t Auto email daily UPS history report
u Send SMS for events notification
v Matches with shutdown software to protect computer’s file saving and shut
down safely
w NetAgent II – 3Ports : Environment Measurement (Optional Kits), External
modem dial in/out via PPP protocol.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MegaTec NetAgent II and is the answer not in the manual?

MegaTec NetAgent II Specifications

General IconGeneral
BrandMegaTec
ModelNetAgent II
CategoryController
LanguageEnglish

Related product manuals