Megmeet MV200 Series - Page 110

110
Fig.6-3 State of digital input terminal
Displaying the ON/OFF state of 6 terminals (X1~X6). “0” means that the terminal is in “OFF” state and “1”
means that the terminal is in “ON” state.
Fig.6-4 State of digital output terminal
The function code P01.19 can display the state of the output terminals (Y1 and Y2) and the relay RO1.
When the signal is output, the corresponding place of P01.19 will be set as 1. For example, if the signals
are output from the terminal Y1 only, the place of BIT0 will be set as 1, therefore, the value displayed by
P01.19 is 1.
P01.20~P01.21 are used to display the analog input signal before the adjustment.
 Note
When the current input is selected for the analog input, the AI input range is 4 to 20mA, and the corresponding
display range is 2 to 10.
P01.23 is used to display the percentage of the analog output relative to the full range. For example, the
function of AO1 is set as “output frequency”. If the maximum frequency is 100Hz and actual running
frequency is 50Hz, P01.23 will displays 50%.
Reserved 0P01.24
Reserved 0P01.22
State of digital output terminal
0~7H
(
0
)
P01.19
Process closed loop erro
r
-100.0~100.0%
(
0.0%
)
P01.27
Process closed loop feedbac
k
-100.0~100.0%
(
0.0%
)
P01.26
Process closed loop reference
-100.0~100.0%
(
0.0%
)
P01.25
AO1 out
p
ut 0.0~100.0%
(
0.0%
)
P01.23
AI2 in
p
ut volta
g
e -10.00~10.00V
(
0.00V
)
P01.21
AI1 input voltage
-10.00~10.00V
(
0.00V
)
P01.20