Megmeet MV200 Series - Page 179

179
When 0 is selected for all the P16.00 and P16.01 BIT bits, the output frequency will be displayed by
default.
In the running parameter display state, the parameters for display can be switched in turn by pressing the
shift key 》.
Fig.6-65 Setting of LED display parameter selection when stop
This parameter defines the parameters that LED can display when the drive is in stop state.
When 0 is selected for the BIT bit, it indicates that the parameter is not displayed.
When 1 is selected for the BIT bit, it indicates that the parameter is displayed.
Note: When the rotating speed or the line speed is displayed, it can be directly changed by pressing ∧
or
∨ key (no need to switch into the frequency state).
When 0 is selected for all the P16.02 BIT bits, the set frequency will be displayed by default.
In the stop parameter display state, the parameters for display can be switched in turn by pressing the
shift key 》.
This function code is used for correcting the line speed proportion display error, and it has no influence on
the actual rotating speed.
This function code is used for correcting the rotating speed proportion display error, and it has no influence
on the actual rotating speed.
This function code is used for correcting the display error between the actual physical parameters
(voltage, flow, etc.) and the reference or feedback parameter (voltage, current) in the PID closed loop
control, and it has no influence on the PID closed loop adjustment.
Rectifier module tem
p
erature
0.0~150.0℃
(
0.0
)
P16.07
Inverte
r
module tem
p
erature
0.0~150.0℃
(
0.0
)
P16.06
Close loo
p
dis
p
la
y
coefficient 0.1~999.9%
(
100.0%
)
P16.05
Rotatin
g
s
p
eed dis
p
la
y
coefficient 0.1~999.9%
(
100.0%
)
P16.04
Line s
p
eed coefficient 0.1~999.9%
(
1.0%
)
P16.03
LED dis
p
la
y
p
arameter selection when sto
p
0~FFFH
(
009
)
P16.02