Mellanox Technologies IS5030Q-2SFC - Figure 46: Power Cord through the Rail Slide; Figure 47: Screwing on the Bracket

QDR InfiniBand Switch Platform User Manual Rev 3.4
Mellanox Technologies
69
Figure 46: Power Cord Through the Rail Slide
3. Tighten the bolts that hold the rail slides onto the rack to 9.2 Nm or 81.5 pound inches.
4. Make sure the cords come out the other side of the rack.
5. Place both brackets on the switch so that they extend forward of the switch.
Figure 47: Screwing on the Bracket
Slot in the rail slide
In this position you will use 4
flat head screws
In this position you will use 3
flat head screws
Place to put
the power
cable.
In this position the front of the switch
is even with the rack vertical support
In this position the front of the switch is
~5cm behind the rack vertical support
This configuration also allows you to put the power
cord through the bracket.