Rev 3.4
Mellanox Technologies
8
Revision History
Table 1 - Revision History Table
Date Revision Description
November 2012 Rev 3.4 • Added Note to Section 3.6.2.2 regarding lack of support for standard length
switch installation with power side next to the vertical support
• Added Figure 17 and Figure 18 and text regarding lack of support for Stan-
dard installation with the connector side deeper in the rack
• Added CCC China Warning
October 2012 Rev 3.3 Added Note to Section 4.3 regarding unmanaged switch
July 2012 Rev 3.2
• Removed references to CD and Quick Start Guide
• Added reference to “Thank You” page
February 2012 Rev 3.1 • Fixed view FW revision command Section 4.3.2
• Added pull out tab section for externally managed switches
December 2011 Rev 3.0 Minor punctuation and grammar fixes.
June 2011 Rev 2.9
• Removed references to paper clip
• Changes to reset button Section 3.1.2
• Added warning do not use the switch as a shelf
June 2011 Rev 2.8 Changed three minute boot up time to 5 minutes
June 2011 Rev 2.7 Removed Flashing green from Table 4
June 2011 Rev 2.6
• Removed products scheduled for End of Life
• Removed Flashing green from Table 4
May 2011 Rev 2.5 Fixed power numbers
May 2011 Rev 2.4 Changes to Section 1.1
and Section 2
May 2011 Rev 2.3 • Changes to the management sections
• Removed Section 6
May 2011 Rev 2.2 • Changed Grounding section.
• Removed note from Table 4
• Changed unmanaged FW update procedure
Oct. 2010 Rev 2.1 Added information regarding the MIS5031 port numbering and port activation
Oct. 2010 Rev 2.0
• New power numbers
• Cable power level changed to 2.0W level 2
July 2010 Rev 1.9.1 Added “QSFP Cable Power Budget Classification”
June 2010 Rev 1.9
• Added section Getting the License
• Added Note “Each Ethernet connector gets connected to Ethernet switches.
These switches must be configured to 10/100M auto-negotiation.”
To Next Page
Loading...
Need help?
General
