Rev 3.4
Mellanox Technologies
10
About this Manual
This manual describes the installation and basic use of the Mellanox IS50XX switch, which is
based on the InfiniScale IV InfiniBand switch device.
Intended Audience
This manual is intended for users and system administrators responsible for installing and setting
up the switch platforms listed above.
The manual assumes familiarity with the InfiniBand
®
Architecture Specification.
Related Documentation
Additional Documentation available from Mellanox:
Conventions
Throughout this manual, the name IS50XX and the term switch are used to describe both the 36-
port QSFP 40Gb/s InfiniBand Switch and the 36-port QSFP 20Gb/s InfiniBand Switch, unless
explicitly indicated otherwise.
Table 2 - Reference Documents
Switch Firmware and
Firmware Update
Tools
See
http://www.mellanox.com > Support > Download Firmware Tools
Note that the Switch System described in this manual is based on Mellanox
Technologies’ InfiniScale
®
IV switch device.
Mellanox OFED
Stack for Linux
User’s Manual
See
http://www.mellanox.com > Support > InfiniBand Software and Drivers
Click “Mellanox OpenFabrics Enterprise Distribution for Linux
(MLNX_OFED)”
Select the Linux User’s Manual
The embedded OS and tools on the CPU in the management module is a
subset of the Mellanox OFED stack.
FabricIT Enterprise
Fabric Management
Software CLI User’s
Manual
See
http://www.mellanox.com > Products > Management Software
Select “FabricIT EFM - InfiniBand Fabric Management"
Click "Software and Documentation Download center"
select User Manual
Mellanox Firmware
Tools (MFT)
User’s Manual
Document # 2329
The MFT (Mellanox Firmware Tools) package is a set of firmware tools.
The manual supplied with this package provides an overview of the firm
-
ware its installation and replacement. The MFT can be downloaded with its
documentation at:
http://www.mellanox.com > Support > Download Firmware Tools
To Next Page
Loading...
Need help?
General
