Memorex MVBD2535 - Network Setup Menu; Wired & Wireless Network Configuration; Network Test & Manual Setup Options

39
SETUP MENU (CONTINUED)
Ifusingawiredinternetconnection,selectWIREDusingthe
Navigation (π,†) buttons, then press the ENTER button,
andtheunitwillautomaticallybeconfiguredtoaccessthe
internet. If successful, you will get the message, Wired
networkconnectionsuccessfullysetup.
Ifusingawirelessinternetconnection,seepages41-42.
CONNECTION
Link Status: If the network connection is active, “Link Up”
appearsbelowLinkStatus.Ifthenetworkconnectionisnot
active,“LinkDown”displaysbelowLinkStatus.
MACAddress:ThiswillshowtheMACAddress.
IPMode:SelectOfftodisabletheinterface.SelectManual
tomanuallyconfigurenetworksettings,suchasIPaddress,
subnetmask,andgatewaysettings.SelectDynamictouse
theDHCPtoautomaticallyobtaintheIPAddress.
YoucanconfiguretheIPAddress,SubnetMask,Gateway,
PrimaryDNSandSecondaryDNS,butitisnotrecommended
unless informed to do so by yourISP provider. Press the
ENTERbuttonwhenconfirmingtheseoptions.
MANUALNETWORKSETUP
NETWORKSETUPMENU:
ToentertheNetworkSetupmenu,whilenodiscisinsertedordiscisintheStopmode,ifnotalreadyattheSetupscreenpress
theHOME/SETUPbutton,select Settingsusingthe Navigation(π,†)buttons andthenpress theNavigation(®) button.
SelectNetworkusingtheNavigation(π,†)buttonsandthenpresstheNavigation(®) button.
The unit will perform a network test. When the test is
complete, a confirmation window will appear. Press the
ENTERbuttontoselect“OK”.
Ifthetestfails,double-checkyourEthernetcableconnection,
wirelessrouter,IPsettings,orcontactyourISP.
NETWORKTEST
INFORMATIONSETUPMENU:
ToentertheNetworkSetupmenu,whilenodiscisinsertedordiscisintheStopmode,ifnotalreadyattheSetupscreenpress
theHOME/SETUPbutton,select Settingsusingthe Navigation(π,†)buttons andthenpress theNavigation(®) button.
SelectInfousingtheNavigation(π,†)buttonsandthenpresstheNavigation(®)button.Theinformationontheunit,such
asSoftwareVersion,SoftwareDate,HardwareVersion,etc.willappear.Theseitemscannotbechanged.
QUICKSETUPMENU:
ToentertheQuickSetupmenu,whilenodiscisinsertedordiscisintheStopmode,ifnotalreadyattheSetupscreenpressthe
HOME/SETUPbutton,selectSettingsusingtheNavigation(π,†)buttonsandthenpresstheNavigation(®)button.SelectQuick
SetupusingtheNavigation(π,†)buttonsandthenpresstheNavigation(®)button.Ifyouselect“Yes,performQuickSetup”,you
canselectOSDlanguage,ResolutionandTVaspect,orselect“No,thanks.I’llgothroughthefullsetupmenulater”toreturntothe
previousmenu.