Need help?Do you have a question about the mensor WIKA CPC8000-H and is the answer not in the manual?
General| Manufacturer | WIKA |
|---|---|
| Model | CPC8000-H |
| Type | Pressure Controller |
| Display | 7" TFT touch screen |
| Communication Interfaces | RS-232, Ethernet |
| Power Supply | 100 ... 240 V AC, 50/60 Hz |
| Operating Temperature | 15 to 35 °C |
| Output Signal | Analog, Digital |
| Housing Material | Aluminum |
Details Mensor's warranty policy for products, covering defects in workmanship and materials.
Information regarding FCC and CE emission standards and potential interference.
Terms and conditions for software usage, licensing, and restrictions on copying.
Information on post-warranty services, repair, and calibration offerings.
Lists key features of the CPC8000-H controller, including range and accuracy.
Describes the pneumatic and hydraulic modules of the CPC8000-H.
Instructions for powering on the instrument and initial system startup.
Explains safety symbols, intended use, and improper use warnings.
Outlines operator duties and required personnel qualifications.
Details necessary PPE, product labels, and safety marks.
Guidelines for checking and handling the instrument during transport.
Instructions for proper packaging and storage conditions.
Instructions for mounting the instrument safely and correctly.
Details ports, connections, and prefilling for the rear panel.
Basic operating procedures, power up, setup, and display features.
Steps for initial configuration and language selection.
How to select applications and input parameters.
Description of main screen, range hold, setpoint, keypad, programs, favorites, units.
Bar graph, control limits, auxiliary displays, and operating modes.
Understanding status bar and accessing settings menu.
General, sensor, control, remote, and applications settings.
Setting up communication parameters and selecting command sets.
Configuring IEEE-488 address and Ethernet settings.
Setting up serial port parameters and cable requirements.
Details of Mensor command set, format, and output.
Lists available SCPI commands and queries for the instrument.
Accessing service/calibration apps and general maintenance advice.
Mensor services and procedures for filling hydraulic media.
Instructions for removing and replacing transducers on both modules.
Automatic calibration, verification, and services.
Viewing calibration data and performing single-point calibration.
Procedures for two-point calibration and linearization.
Safety warnings for dismounting due to residual media and hazards.
Guidelines for returning the instrument for service.
Instructions for environmentally compatible disposal of components.
Accuracy and precision for reference pressure sensors.
Details on versions, weight, connections, and media.
Details on instrument version, display, connections, and communication.
Lists EC declarations, directives, and calibration certificates.
Technical drawings and dimensions of the unit with rack.
Technical drawings of the hydraulic module.
Technical drawings of the pneumatic controller.
Details on barometric sensor and its calibration sled.
Information on calibration sleds for reference pressure transducers.
Information on factory-available operating fluids.
Table listing measurement codes, descriptions, and output formats.
Table of conversion factors to and from PSI for various units.
To Next Page
