Page 116 www.menzimuck.com
Working with the machine
1
2
Shut off the Diesel engine
After the engine rundown time:
1. Set the speed potentiometer anticlockwise to the minimum engine speed.
2. Turn the ignition key anticlockwise to Position 0 and then remove the igni-
tion key.
2
1
Attention !
A full load when the engine and hydraulic system are
cold
• Can result in damage to property.
• Operate the engine without a load for 1 - 2 minutes after star-
tup or at a maximum speed of 1200 rpm. Increase this period
by 2 - 4 minutes if the engine is operated below freezing
point. The engine and the hydraulic system are thereby hea-
ted up slightly, thereby reducing wear to the engine.
Warning !
Defective armrest switch
• Can result in death or severe injuries.
• Check the armrest switch on the left armrest by: pulling up
the left armrest (1) - moving the right joystick (2) to the left
and the right. These or any other operations must not cause
anything to move.
Attention !
Immediately shutting off the engine after a full load
• Can result in damage to property.
• Before shutting off the engine, which has been operated
• under a workload, allow it to run for at least 2 minutes at
1000 - 1200 rpm until hot engine parts cool down.
To Next Page
Loading...
