44
Chapter 10
Specify Your Network Settings
3. Go to Advanced > Network > Static Routing.
4. Click Add to add a new static routing entry. Finish the settings according to the
following explanations:
• Network Destination - The destination IP address that you want to assign to a
static route. This IP address cannot be on the same subnet with the WAN IP or
LAN IP of the router. In the example, the IP address of the company network is
the destination IP address, so here enters 172.30.30.1.
• Subnet Mask - Determines the destination network with the destination IP
address. If the destination is a single IP address, enter 255.255.255.255;
otherwise, enter the subnet mask of the corresponding network IP. In the
example, the destination network is a single IP, so here enters 255.255.255.255.
• Gateway - The IP address of the gateway device to which the data packets will
be sent. This IP address must be on the same subnet with the router’s IP which
sends out the data. In the example, the data packets will be sent to the LAN port
of Router 2 and then to the Server, so the gateway should be 192.168.1.2
• Interface - Determined by the port that sends out the data packets. In the
example, the data is sent to the gateway through the LAN port.
5. Select the checkbox to enable this entry.
6. Click Save to save the settings.
Done!
Open a web browser on your PC. Enter the company server’s IP address to visit the
company network.
To Next Page
Loading...
