55
Chapter 11
Administrate Your Network
11. 10. ICMP Ping
ICMP (Internet Control Message Protocol) Ping is used to diagnose the network by
sending ICMP echo request packets to the target remote or local host and waiting for
an ICMP response.
1. Visit http://mwlogin.net, and log in with the password you set for the router.
2. Click Advanced > System Tools > Administration page. Locate the ICMP Ping
section.
3. Select Remote if you want the computers on a public network to ping the router’s
WAN IP address. Select Local if you want the computers on a private network to
ping the router’s LAN IP address. Or select both.
4. Click Save to make the settings effective.
11. 11. System Log
System Log can help you know what happens to your router, facilitating you to locate
the malfunctions. For example when your router does not work properly, you will need
to save the system log and send it to the technical support for troubleshooting.
1. Visit http://mwlogin.net, and log in with the password you set for the router.
To Next Page
Loading...
