User Manual : Source - Destination Editing
User Manual
190
When Gates are set the following Source-Destination operations available in the Edit menu can be
applied:
• Auto-Edit Source to Destination
• Overwrite Source to Destination
• Insert Source to Destination
• Replace Source to Destination
• Fit Source to Destination
When the Source has only 1 Gate then the region to edit can be automatically adjusted to the end (or
beginning in case of a single Gate Out) of the clip under the Gate when the edit operation is performed.
This is available by choosing the menu item:
Edit > Source – Destination Settings > Limit 1 Gate Sources to End/Beginning of clip.
When the Source has 2 Gates set and the Destination has 1 Gate set, then the behavior of the Auto-
Edit Source to Destination operation can be chosen between Overwrite or Insert by choosing the menu
item:
Edit > Source- Destination Settings > 3 Gates Auto-Edit does Overwrite/Insert
The menu item:
Edit > Source - Destination Settings > Auto Set Destination Gate In after Edit
allows the Destination Gate In to be set to the previous Destination Out point after any Source-Destina-
tion operation. This automatically prepares the Destination for the next operation. The Destination is
also automatically centered around the new Gate In.
The menu item Edit > Source - Destination Settings > Auto Set Destination Gate In after Edit
allows the Destination Track Group to be automatically selected after any Source-Destination operation.
All these operations works independently of the Auto-Ripple mode (they have their own overwrite/ripple
modes described in the table on the next page) but follow the Auto-Crossfade settings accessible in the
menu Edit > Auto-Crossfade.
Keyboard Shortcuts
Note: Most Source Destination operations are available as Keyboard Shortcuts.
To Next Page
Loading...