User Manual : Source - Destination Editing
User Manual
191
Source-Destination
operations
Source
Gate In OR Gate Out Only
Source
Gate In & Gate Out
Destination
Gate In OR Gate Out Only
Auto-Edit: Performs 2 points
editing by doing the following
Overwrite operation.
Overwrite: Copies material
FROM Source Gate In to the end
of the Track or from start of Track
to Gate Out
TO Destination Gate In or Desti-
nation Gate Out by overwriting
Destination material
Auto-Edit: Performs 3 point editing by
doing the following Overwrite or Insert
operation depending which one is selected
in the menu Edit > Source-Destination
Settings.
Overwrite: Copies material between
Source Gate In and Source Gate Out to
Destination Gate In or Destination Gate
Out by overwriting Destination material
Insert: Copies material between Source
Gate In and Source Gate Out to Destina-
tion Gate In or Destination Gate Out by rip-
pling Destination material
Destination
Gate In & Gate Out
Auto-Edit: Performs 3 points
editing by doing the following
Overwrite operation.
Overwrite: Copies material from
Source Gate In or Source Gate
Out to Destination Gate In and
Gate Out by overwriting Destina-
tion material
Auto-Edit: Performs 4 point editing by
doing the following Replace operation.
Overwrite: Copies material between
Source Gate In and Source Gate Out to
Destination Gate In by overwriting Destina-
tion material.
Insert: Copies material between Source
Gate In and Source Gate Out to Destina-
tion gate In by rippling Destination material
Replace: Replaces material between Des-
tination Gate In and Gate Out by material
between Source Gate In and Source Gate
Out by rippling the Destination material
Fit: Replaces material between Destina-
tion Gate In and Gate Out by material
between Source Gate In and Source Gate
Out by stretching or squeezing the Source
material
To Next Page
Loading...