Metos PROVENO E - Operation Procedures Overview; Control Panel and Tilting

|
23
PROVENO E
Rev. 1.2 (24.08.2016)
Operation instructions
4.2. Operation procedures
4.2.1. Operating the control panel - General
When the appliance is started with the ON/OFF switch, all displays and indicator lights on the control
panel illuminate for a short time (display test). After that, ‘On’ remains on the temperature display and the
time on the timer display (if the kettle is fi tted with a timer function). The appliance is now ready for use.
The same logic is repeated in all button functions of the control panel.
Selecting/activating a function:
Press briefl y the appropriate button and then set the value desired using the central dial, for
example:
The appliance waits for the value for three seconds (the selected display is blinking), whereafter the
appliance starts to perform the function according the set value. In some functions, e.g. in automatic
water fi ll, a second press is still needed to confi rm and activate the function before the function starts
to operate.
Stopping/cancelling a function:
Press the appropriate button for a long time (approx. 2 seconds).
4.2.2. Tilting the kettle
It is not possible to tilt the kettle when the lid is closed. In case you try to tilt the kettle with the lid in a
closed position, a blinking ‘Lid’ message appears on the display.
Tilting the Proveno kettle is carried out by pressing the tilting button.
The kettle tilts as long as the button is held down. In case the “pull-back” function is on, (see “Adjust-
ment instructions, Setting customer specifi c parameters”), a slight reversing movement occurs after the
button is released, which decreases dripping of food from the the spout.
In case the kettle is tilted to its extreme position, the reversing movement making the kettle completely
empty does not occur.
Tilting the kettle to the cooking position is carried out by pressing the upright position button.
For safety reasons (safety regulations), the reversing movement lasts only as long as the button is pres-
sed. The upright position button must be pressed so long that the reversing movement stops and the
kettle is in the cooking position. In case the kettle is not reversed up to the cooking position, a blinking
‘PoS’ message appears on the display when you try to switch the heating or mixing on.