Metos PROVENO E - Timer Functions

30
|
PROVENO E
Rev. 1.2 (24.08.2016)
Operation instructions
4.2.11. Timer functions
Setting the time
Setting correct time by the clock is necessary to make timing and data collection possible.
Press and simultaneously hold down for about 2 seconds.
Set the time.
Start selecting the time within three seconds after the timer display begins to blink. When you have set
the time, it will be saved automatically in the memory after about three seconds, and the timer starts up.
Setting the date
Setting the correct date is necessary to make the data collection possible.
Press and simultaneously keep pressed.
In about 2 seconds, the timer display starts blinking.
Continue holding the button down until ‘Yr’ blinks on the timer display and two last digits of the year
illuminate. Release the buttons.
If needed, select a new year within 3 seconds.
After the year is locked, ‘Mo’ and a month begin to blink on the timer display.
If needed, select a new month within 3 seconds.
After the month is locked, ‘dY’ and a day of the week begins to blink on the timer display.
If needed, select a new day within 3 seconds.
After the day is locked, the timer display begins to show the actual time.