24
|
PROVENO E
Rev. 1.2 (24.08.2016)
Operation instructions
4.2.3. Positioning the mixing tool and scrapers
Attach the scrapers by placing the pins on the mixing tool into the holes on the scrapers. After that turn
the scraper into place by lifting the scraper’s lower part. Finally pull the scraper forward. The bevel (1) will
on the lower scraper point upwards and on the side scraper away from the mixer axle.
The mixing tool is equipped with 1-5 scrapers, depending on the size of the tool.
Scraper
40 60 80 100 150 200 300 400
Scraper A2
-1121212
Scraper B2 (bottom)
--111111
Scraper C2 (bottom)
11--1122
Use scrapers in all cooking modes to increase the effi ciency of heat transfer and to help the cleaning of
the kettle.
To Next Page
Loading...
