|
43
PROVENO E
Rev. 1.2 (24.08.2016)
Operation instructions
The dosing and impact time instructions for cleaning detergents must be followed - e.g. exceeding the
impact time for foam cleaning detergents in combination with salt residues has been observed to cause
severe spot corrosion even on stainless steel.
The manufacturer does not take any responsibility for possible damage caused by not following the
instructions above.
Detaching the lid parts
• Make sure the kettle is in an upright position.
• Place the lid on the kettle.
• Remove the cover of the safety grid and detach the safety grid.
• Detach the solid lid from the lifting arm by pulling at the locking lever of the lid.
Refi tting the lid parts
Place the solid lid on the kettle approximately in the correct position.
Pull the lifting arm down over the lid. Turn the solid lid so that the guiding pin lines up with the hole in the
lifting arm center piece.
1. Solid lid
2. Lifting arm
3. Guiding pin
4. Locking lever of the lid
5. Safety grid for lid opening
6. Cover for fi ll opening
12
3
4
5
6
To Next Page
Loading...
