|
13
VIKING 4G E, S
Rev. 1.0 (29.1.2020)
Operation instructions
4. Operating instructions
STOP
All personnel using the appliance must be given training in how the appliance works by the
person responsible for staff safety.
4.1. Regular checks
4.1.1. Before the fi rst use
Before using the kettle for the fi rst time or if it has been unused for a long time
• Clean the kettle thoroughly with warm detergent solution and remove the dust and dirt with a cloth.
Dry all surfaces after cleaning.
4.1.2. Daily
Electrically heated models:
Check that:
• The kettle is in its upright and horizontal position. The kettle does not heat if it is tilted.
• That the water supply (hot/cold) is open.
• That no inappropriate objects in the kettle.
• The scrapers are correctly attached to the mixing tool. See “Positioning the mixing tool and scraper”.
• The mixing tool has been locked in its place: locking part (one end of the handle) in the groove of the
mixer axle, with the handle turned in a horizontal position. Secure fi xing by trying to lift the tool out of
the kettle by the upper blade.
• The steam generator has the right amount of water (white water level indicator light on the control
panel of the Viking kettle, normally water must be refi lled a few times per year).
Steam heated models:
Check that:
• The kettle is in its upright and horizontal position. The kettle does not heat if it is tilted.
• That the water supply (hot/cold) is open.
• That no inappropriate objects in the kettle.
• The scrapers are correctly attached to the mixing tool. See “Positioning the mixing tool and scraper”.
• The mixing tool has been locked in its place: locking part (one end of the handle) in the groove of the
mixer axle, with the handle turned in a horizontal position. Secure fi xing by trying to lift the tool out of
the kettle by the upper blade.
• Surplus condensate water has been drained off from the steam jacket as needed.
To Next Page
Loading...