|
29
VIKING 4G E, S
Rev. 1.0 (29.1.2020)
Installation
6. Installation
6.1. General
Please observe the instructions given in this chapter concerning the installation and adjustments that
must be done before taking the kettle into use. Strict observance of the instructions prevents malfunc-
tions and damages potentially caused by defective installation.
Do not switch the power on if the installation place is damp or wet (building site conditions).
6.1.1. Operating conditions
The kettle can be used in a normal, air-conditioned professional kitchen. The room temperature of the
installation place must not exceed +40°C and the relative humidity must be less than 80% (condensation
on surfaces not allowed to occur). If the temperature of the facility in winter conditions is below 0°C, the
steam generator of the kettle must be drained and the kettle must be emptied to avoid damage caused
by freezing. The kettle’s pipes and solenoid valve bodies must be emptied at the same time.
6.1.2. Possible interference from the surroundings (to the surroundings)
The kettle fulfi ls the requirements of the EMC directive concerning the emissions and immunity to electro-
magnetic disturbances. In case there are electronically controlled appliances and, in particular, devices fi tted
with a frequency converter in the installation place, it is recommended to ensure their conformity with the
relevant regulations and that their cabling has been done according to instructions.
6.1.3. Storage
The kettle must be stored in a dry place, at a temperature between +10 and +40°C. The kettle should be
kept in its transport package during storage.
If the appliance is stored in construction site conditions, special care must be taken not to damage it
through other operations on the site.
• Protect the exterior of the kettle from scratches and knocks.
• Protect the kettle from construction site dust.
• Protect the kettle from sparks produced by welding, grinding and abrasive cutting wheels. The-
se can later cause rust spots on the stainless steel surface of the appliance.
6.1.4. Unpacking the appliance
The kettle should be transported in its own package as close as possible to the installation place before
fi nal unpacking. Do not remove the protective fi lm until after installation, just before the fi rst use of the
kettle.
After removing from the transport pallet, the kettle is not stable until it has been bolted down to the
installation frame. It is strictly forbidden to operate or tilt the kettle before it has been fi xed to the fl oor or
to the free standing frame according to the installation instructions. When the kettle is removed from its
transport pallet, it must be supported to prevent it from falling before it is fi xed to the fl oor. If the kettle
falls down, this may cause injury to people or damage to property.
To Next Page
