|
7
VIKING 4G E, S
Rev. 1.0 (29.1.2020)
Safety
2.6. Warnings
Please take careful note of the following instructions and warnings. Further on in this manual, there are
warnings which are to be noted in special operation situations. To prevent damage and accidents, please
read the whole manual before attempting to operate the appliance.
• Viking kettles are to be used only for food preparation. Interacting or corrosive substances are not to
be prepared in the kettle. Note that also long-term effect of some food preparation substances, such
as salt, acetic acid, lemon acid and lactic acid, can be corrosive.
• To prevent burns, do not during the use touch the inner surface and the rim of the kettle, safety lid and
mixing tool. Do not put your hands, without appropriate protection, above the kettle while cooking.
• Beware of hot steam when removing the lid.
• Do not open the control valve of the steam generator, the safety valve or the water inlet valve when
there is pressure in the steam jacket. Releasing hot steam might cause burns.
• Do not stand behind the kettle during tilting.
• The mixer must be turned off before removing the mixing tool.
• Do not push utensils or your fi ngers through the openings in the safety lid into the kettle during mi-
xing.
• It is under all circumstances absolutely forbidden to use the mixer without the safety lid.
• To prevent stress injuries do not lift the mixing tool from the kettle when it is in a vertical position. Tilt
the kettle in a horizontal position and remove the mixing tool. We recommend the use of a trolley to
help removing of the mixing tool of larger kettles (200-400 l).
• After using the kettle, check that the shower gun and the water inlet tap of the kettle are closed.
• After using the kettle, clean it according to the cleaning instructions given in this manual to keep the
high hygiene level.
• It is forbidden to use the kettle without cover plates or if the cover plates are not properly fi tted.
• The factory pre-set program parameters of the kettle and mixer may only be changed by authorized
personnel according to the instructions given by the factory.
• Beware of sharp edges on the sheet construction inside the kettle pillars during installation and ser-
vice work.
• The following danger of electrical shock mark is fi tted on cover plates protecting electrical compo-
nents from being touched which would cause danger to life.
STOP
The manufacturer will not take responsibility for potential damage caused to units or persons if the given
instructions have not been followed.
To Next Page
Loading...
