40
|
VIKING 4G E, S
Rev. 1.0 (29.1.2020)
Installation
1
2
3
4
1. Front plate
2. Mains switch
3. Rear plate
4. Screw
Turn the mains switch (2) to the OFF position.
Detach the rear cover plate (3) by opening the screws (4).
6.7. Electrical connections
The electrical connections of the kettle can only be carried out by a qualifi ed electrician having the neces-
sary competence for the installation and service of electrical appliances.
The control pillar cover plate is a fi xed component, not intended for detaching. Do not force it upwards
when removing the front and rear cover plates.
To make the electrical connections, the upper left-hand side plate, where the mains switch is located,
must be removed.
STOP
To Next Page
Loading...
