99-2003 FINAL ASSEMBLY
ALL VEHICLES
1. Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and indi-
vidually tape off the ends of any unused wires to prevent electrical short cir-
cuit.) See figure A
2. Re-connect the battery terminal and test the unit for proper operation.
3. Reassemble dash in the reverse order of your specific vehicle's Dash
Disassembly.
A
A
B
C
D
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
50
To Next Page
Loading...
