By presenting RFID media or fingerprint again, or typing-in the
PIN code the locker unlocks and is free for another user.
Normal locking procedure with RFID media
STEP 1: Close the locker door. Time countdown starts
(vertical lines are displayed) on the Display and
interrupted beep acoustic signal is activated.
STEP 2: Approach the RFID media to the antenna field.
Reading distance is 2 – 5 centimetres from the device
surface. Hold the RFID media in the field for a few
moments for device to read and process it.
STEP 3: When the RFID media is accepted as a locker key
the corresponding locker is locked and its number is
displayed.
MULTI LOCKING:
If the user RFID media supports multiple locking, you can
lock multiple lockers on the same or different devices.
Number of allowed locked lockers is set in Metra SW.
To lock multiple lockers, repeat previously described
three steps on different lockers.
To Next Page
Loading...
