NOTE: If fingerprint was chosen sign “FP” is flashing and
beep acoustic signal is heard. Insert your finger in the
Fingerprint module.
STEP 3: If correct PIN code is entered / fingerprint
presented, sign “ALL” is displayed.
Now you can either confirm the unlocking of all lockers
closed in multi mode by pressing the key or you can
enter the number of single locker and confirm it by
pressing the key.
STEP 4 A: If “ALL” was confirmed corresponding lockers
start to unlock and open one after another and
corresponding locker numbers are displayed.
STEP 4 B: If single locker number was entered,
corresponding locker unlocks and opens. Its number is
also displayed.
NOTE
If sign “Euro” / “Coin” / ”GbP” / ”PAY” / “USd / “CHF” is displayed instead of locker number,
continue with the procedure described in paragraph “Exceeded tenancy time”! Additional
payment is required for each locked locker with exceeded tenancy time.
If sign “bLOC” is displayed instead of locker number, see paragraph “Expired tenancy time”!
Multiple unlocking procedure (User key and Multi key)
User keys that support multiple locking and Multi keys have the same unlocking procedure.
Procedure describes standard multi unlocking procedure, but with the Display Combo and Display
Keypad you can also use an alternative procedure similar to the one described in the paragraph
“Locker locked with PIN code” or “Locker locked with fingerprint” when you want to unlock single
locker at a time. After entering the locker number, “Card” is displayed and instead of entering the
PIN code or inserting your finger into the fingerprint module, you present your user or multi key to
unlock the locker. See also note at the end of this paragraph.
To Next Page
Loading...
