Metra Electronics ELS - Master Code Configuration; Setup Code Configuration

Page 29
Metra ELS User Manual
 Key
and
 Key
Up Key
Down Keys
Cancel
For scrolling UP
through the menus.
For scrolling DOWN
through the menus.
Confirm selection
 Actions and Parameters
PARAMETER
MASTER CODE
Not avaliable if “Special Keys Mode” is set to “On-line” in Metra ELS/LCC NET software.
While sign “CodE” is displayed press the  key. Sign “nbr” is displayed. Type in the number from 1 to
5 (Up to 5 different Master Codes can be stored). Master Code can be up to 16 digits long. Display
shows digit position (01 to 16) and digit (0 to 9) separated by “-“.
The new Master Code must be typed in again to confirm it. Sign “ConF” is flashing on the display.
Type in the new Master Code again and confirm it with the  key. If new Master Code is confirmed
correctly, sign “YES” is displayed otherwise sign “no” is displayed. Device returns to parameter
selecting mode.
 NOTE 
If the Master Code under the number you entered already exists, after you press the  key the
Master Code is displayed digit by digit (Display shows digit position (01 to 16) and digit (0 to 9)
separated by “-“). After the last digit of the code is displayed, sign “CodE” starts flashing. You can
cancel the procedure with  key or continue with entering new code by pressing on the key for first
digit of the new Master Code.
PARAMETER
SETUP CODE
Not avaliable if “Special Keys Mode” is set to “On-line” in Metra ELS/LCC NET software.
While sign “SCod” is displayed press the  key. Sign “nbr” is displayed. Type in the number from 1 to
5 (Up to 5 different Setup Codes can be stored). Setup Code can be up to 16 digits long. Display
shows digit position (01 to 16) and digit (0 to 9) separated by “-“.
The new Setup Code must be typed in again to confirm it. Sign “ConF” is flashing on the display. Type
in the new Setup Code again and confirm it with the  key. If new Setup Code is confirmed correctly,
sign “YES” is displayed otherwise sign “no” is displayed. Device returns to parameter selecting mode.
 NOTE 
If the Setup Code under the number you entered already exists, after you press the  key the Setup
Code is displayed digit by digit (Display shows digit position (01 to 16) and digit (0 to 9) separated by
“-“). After the last digit of the code is displayed, sign “SCod” starts flashing. You can cancel the