7.5 Carrying out titrations using the sample table
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
52
￭￭￭￭￭￭￭￭
916 Ti-Touch
￭ Fill out the fields for sample identification and the sample size.
The line number is automatically increased by one after the sam-
ple size has been entered. The next sample size can be entered
directly.
The criterion, after which the line number should be increased by
one, can be modified in the properties dialog of the sample table
under [Editing options].
￭ Use [ ] to return to the sample table.
￭ Switch to the main dialog with [ ] after the desired number of
sample data has been filled in.
7.5 Carrying out titrations using the sample table
Now carry out the titrations with the samples for which you have entered
sample data.
Each time that you press [ ], the sample data will be loaded from the
top line of the sample table and applied for the current titration. This line
will be deleted at the end of the titration. The sample data of the next line
down will be used for the next titration.
A result report will be printed out and a PC/LIMS report will be saved after
each titration if you have activated these options.
To Next Page
Loading...
Need help?
General
