￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Switching the instrument on and off and selecting the dialog language
916 Ti-Touch
￭￭￭￭￭￭￭￭
11
3 Switching the instrument on and off and
selecting the dialog language
3.1 Switching the instrument on and off
Switching on the instrument
Caution
Peripheral devices (e.g. printers) must be switched on before you switch
on the 916 Ti-Touch.
Proceed as follows:
1
￭ Press the mains switch on the left-hand side of the rear panel of
the 916 Ti-Touch.
The 916 Ti-Touch is initialized. A system test is performed. This
process takes some time.
￭ If a buret unit is attached, then a request appears to carry out the
Prepare function:
All tubings and the cylinder are rinsed with the Prepare function.
The preparing of the buret unit is described in the chapter Manual
control of the detailed manual.
￭ Confirm the message with [OK].
The main dialog is displayed:
To Next Page
Loading...
Need help?
General
