8.1 Creating a user list
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
54
￭￭￭￭￭￭￭￭
916 Ti-Touch
8 Setting up the user administration
If different persons are working on the instrument, we recommend that
the user administration of the 916 Ti-Touch be used. This means that
everyone can use their user identification to log on to the instrument. The
reports will then automatically contain the respective user name.
In addition, a dialog level can be set up for each user. In addition to the
expert dialog, with access to all functions and settings, a routine dialog
can be selected with limited access rights. The available functions and dia-
log areas can be configured for the routine dialog.
Administrator rights can be assigned to users who are permitted to
administer methods and to make configuration settings.
If you create a user list, then you can use it in different ways. You can
apply different combinations of login options. Three possibilities are listed
in the following:
￭ User name can be selected in the main dialog without login.
￭ Automatic login with USB flash drive.
￭ Login with password.
8.1 Creating a user list
The creation of a user list is required for all of the possibilities of the user
login.
Defining users
Proceed as follows:
1
Open the user administration
￭ In the main dialog, tap on [System].
￭ Tap on [System settings].
￭ Tap on [User admin.].
To Next Page
Loading...
Need help?
General
