Metrohm 930 Compact IC Flex - Installing the Amperometric Detector; Connecting the Sample Degasser (Optional)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Installation
930 Compact IC Flex Oven SeS/PP/Deg (2.930.2560)
￭￭￭￭￭￭￭￭
29
4.16 Installing the amperometric detector
The 930 Compact IC Flex provides enough space for one detector and
additional accessories in the detector chamber. The detector is available as
separate device and is supplied with a separate manual.
Placing the detector in the instrument
Follow the instructions in the chapter Inserting the detector in the manual
for the detector.
4.17 Connecting the sample degasser (optional)
Gas bubbles in the sample lead to poor reproducibility, as the amount of
sample in the sample loop is not always the same. Therefore, we recom-
mend degassing samples that contain gas before injection.
NOTE
The sample degasser does not have to be connected. We recommend
only using the sample degasser if the application requires it.
The rinsing time increases by at least two minutes when the sample
degasser is connected.
Accessories
For this step, you need the following accessories:
￭ 2 × pressure screw, long (6.2744.090)
￭ PTFE capillary (6.1803.040)