Metrohm 930 Compact IC Flex - Safety Guidelines; Operator Responsibility and Personnel Requirements

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
930 Compact IC Flex Oven SeS/PP/Deg (2.930.2560)
￭￭￭￭￭￭￭￭
III
Table of contents
1 About these short instructions 1
2 Introduction 2
2.1 Instrument description ......................................................... 2
2.2 Intended use ......................................................................... 4
2.3 Safety instructions ................................................................ 5
2.3.1 General notes on safety ........................................................... 5
2.3.2 Electrical safety ........................................................................ 5
2.3.3 Tubing and capillary connections ............................................. 6
2.3.4 Flammable solvents and chemicals ........................................... 6
2.3.5 Recycling and disposal ............................................................. 6
2.4 Symbols and conventions .................................................... 7
3 Overview of the instrument 8
3.1 Front ...................................................................................... 8
3.2 Rear ........................................................................................ 9
4 Installation 11
4.1 Setting up the instrument .................................................. 11
4.1.1 Packaging .............................................................................. 11
4.1.2 Checks .................................................................................. 11
4.1.3 Location ................................................................................ 11
4.2 Capillary connections in the IC system ............................. 11
4.3 Removing transport locking screws .................................. 12
4.4 Connecting the drainage tubing and leak sensor ............ 14
4.4.1 Installing the drainage tubing ................................................ 14
4.4.2 Connecting the leak sensor .................................................... 15
4.5 Column oven ....................................................................... 16
4.6 Connecting the eluent bottle ............................................. 16
4.7 Connecting the eluent degasser ........................................ 18
4.8 Installing the high-pressure pump .................................... 19
4.9 Installing an inline filter ..................................................... 19
4.10 Installing the pulsation absorber ...................................... 19
4.11 Injection valve ..................................................................... 19
4.12 Metrohm Suppressor Module (MSM) ............................... 19
4.12.1 Inserting the rotors ................................................................ 20
4.12.2 Connecting the Metrohm Suppressor Module (MSM) ............. 21