Mettler Electronics Sonicator Plus 930 - Page 11

Sonicator Plus 930 Instruction Manual— Rev.J_09/13/17
11

Stimulation or ultrasound output displays
00
0
LED’s that display the output intensity during a treatment. When the
unit is in the “Hold” mode for electrical stimulation, “--- ---“ will be
displayed. When the unit is in the “Hold” mode for therapeutic
ultrasound, the output intensity will be displayed but the “Active
Ultrasound Output” indicator will be off and the timer will not be
running.
12
LED indicators are lit to define which output intensity is being
displayed in the two windows.
mA
W
mA
2
W/cm
LED indicators are lit to show the measurement units of the output
intensity being displayed in the window.
Output intensity control knob, rotate knob clockwise to increase output
and counterclockwise to decrease output.
I
Mains On.
O
Mains Off.
Attention, consult instruction manual.
Symbol for “Consult instructions for use.”
Diagram of Pulsed Mode duty cycles
Type BF Equipment—Class I
Non–ionizing radiation
IPX7
Protected against the effects of immersion.
CE Mark