Need help?Do you have a question about the MicroAir Avionics M760 and is the answer not in the manual?
General| Weight | 1.1 kg |
|---|---|
| Dimensions | 146 x 57 x 165 mm |
| Channels | 760 |
| Modulation | AM |
| Operating Temperature | -20°C to +55°C |
| Frequency Range | 118.000 to 136.975 MHz |
| Channel Spacing | 8.33 kHz / 25 kHz |
| Sensitivity | 2.0 µV |
Lists the revision history and dates of changes made to the manual.
Details what is included with the M760 transceiver package.
Instructs users to read the manual before installation or operation.
Describes the information found on the M760's nameplate.
Explains the purpose of the CASA form 1 release certificate.
Critical warnings against oversizing mounting holes and using longer screws.
Step-by-step guide for soldering wires to the DB15 connector.
Mentions acceptable antenna types like whip and dipole.
Instructions for mounting antennas on metal-skinned aircraft.
Instructions for mounting antennas on non-metal skinned aircraft.
Explains how the backlighting is activated via supply voltage.
Advice on saving battery power by disabling backlighting.
Details Electret microphone characteristics and wiring polarity.
Explains Dynamic microphone requirements, including amplifier use.
Explains how to adjust sidetone for headset volume.
Details how to adjust microphone gain for audio quality.
Explains the RS232 data connection and parameters for SL30 interface.
Explains the 'a' field in commands related to transceiver function (N, M, O).
Describes the 'a' field in commands related to transceiver status (R, M, T, S, F).
Recommends installing a power filter to smooth the power supply and reduce noise.
Explains using ferrite chokes on wiring to reduce RFI noise.
Explains the function of the priority switch to select memory channel 99.
Details how to turn on the radio, adjust volume, and set squelch.
Explains the meaning of the LED colours (green, red, flashing red).
Describes how the mode switch cycles through operational modes (Active/Standby, Channel, VOX).
Explains how the toggle switch exchanges frequencies and activates monitor function.
Details how to adjust frequencies, move the cursor, and scroll through memory channels.
Explains the function of the remote memory button, similar to the toggle switch.
Describes the PTT button's function for transmitting and its limitations.
Explains how to monitor active and standby frequencies and swap them.
Details tuning in the NAV band and the transmitter disabling below 118MHz.
Explains how to activate the monitor function to listen to both frequencies.
Describes storing up to 99 channels with frequency, location, and service.
Explains the VOX intercom feature and how to set the threshold level.
Lists available items in the program menu: CD, VOX, MONITOR, NEW MEM, EDIT MEM, EXIT.
Explains the CD Lockout feature to prevent transmission during reception.
Details enabling/disabling the internal VOX intercom and its threshold setting.
Allows adjustment of the monitor function's sample interval rate.
Steps to program a new memory channel with frequency, location, and service.
How to set the frequency for a new memory channel.
How to set the location name for a new memory channel.
How to select or enter a service description for a memory channel.
Allows editing, changing, or clearing existing memory channels.
Exits the program menu and initiates memory sorting.
To Next Page
