MicroAir Avionics M760 - Channel Mode Operation

Microair Avionics M760 Transceiver Installation & User Manual
M760Q Install & User Manual 01R12.doc Page 26 of 36 30
th
March 2010
5.3 CHANNEL MODE
The M760 has a memory database which can store up
to 99 channels.
Each channel can be programmed with any available
frequency from 108.000MHz to 136.975MHz, and is
named with a 4 character location and 3 character
service description.
Refer to the PROGRAM MODE Menu (sections 6.4
& 6.5) for the programming of memories.
When operating in channel mode, the programmed channels can be scrolled through alphabetically, by
rotating the frequency adjust knob, or by pressing the remote memory button. Only programmed
memories are displayed.
When changing operational modes the Active Frequency is carried forward to the next mode to avoid
an accidental change in channel.
When the operational mode is changed to channel mode, the
M760 will check all memory channels for the current active
frequency. If it finds the current active frequency it will display
the memory channel that corresponds to the current active
frequency. If the current active frequency is not found in any
memory channel a ‘?’ will be displayed on the bottom line.
The user can use the frequency adjust knob to scroll alphabetically through the memory channels
Channel Frequency
Service
Location