Microhard Systems IPN4G - Page 169

© Microhard Systems Inc. 169
5.0 AT Command Line Interface
AT+MCTMTC
Command Syntax
Set Comport modbus TCP configuration.
AT+MCTMTC=<Status>, <Protection status>,
<Protection Key>
Status and Protection Status:
0 Disable
1 Enable
Description
Example
Input:
AT+MCTMTC=0,0,1234<enter>
Response:
OK
AT+MCTIPM
Command Syntax
Set the Comport serial port IP Protocol Mode.
AT+MCTIPM=<Mode>
Mode:
0 TCP Client
1 TCP Server
2 TCP Client/Server
3 UDP Point to Point
4 UDP Point to Multipoint(P)
5 UDP Point to Multipoint(MP)
6 UDP Multipoint to Multipoint
7 SMTP Client
9 SMS Transparent Mode
11 GPS Transparent Mode
Description
Example
Input:
AT+MCTIPM=1<enter>
Response:
OK
AT+MCTTC
Command Syntax
Set Comport TCP Client parameters when IP
Protocol Mode is set to TCP Client.
AT+MCTTC=<Remote Server IP>, <Remote
Server Port>, <Outgoing timeout_s>
Description
Example
Input:
AT+MCTTC=0.0.0.0,20002,60<enter>
Response:
OK