Microhard Systems pMDDL5824 - Page 106

© Microhard 106
5.0 AT Command Line Interface
Wireless (Radio) AT Commands (Continued)
AT Command Description Syntax Effect
AT+MWVMODE Get/Set radio mode AT+MWVMODE[=<Virtual Interface Mode>]
<Virtual Interface Mode> :
0 - Master
1 - Slave
2 - Repeater
3 - Mesh
AT&W
AT+MWVRATE Get/Set radio TX Rate AT+MWVRATE[=<Virtual Interface TX Rate>]
<Virtual Interface TX Rate> :
0 - auto (Recommended)
1 - 64-QAM 5/6 FEC
2 - 64-QAM 3/4 FEC
3 - 64-QAM 2/3 FEC
4 - 16-QAM 3/4 FEC
5 - 16-QAM 1/2 FEC
6 - QPSK FEC 3/4
7 - QPSK FEC 1/2
AT&W
AT+MWEXTADDR Get/Set radio extended addressing AT+MWEXTADDR[=<Extended Addressing>]
<Extended Addressing> : 0 - Off
1 - On
AT&W
AT+MWNETWORKID Get/Set radio Network ID AT+MWNETWORKID[=<Network ID>]
<Network ID>
Radio Virtual Interface Network ID: 1-64 characters
AT&W
AT+MWVENCRYPT Get/Set radio Encryption Type & Key AT+MWVENCRYPT[=<Encryption Type>[,<Key>]]
<Encryption Type>
Radio Virtual Interface Encryption Type:
0 - Disabled
1 - AES-128
<Key>:
Min 8 characters, Max 64 characters
AT&W
AT+MWRESYNC RF Re-Sync from the slave side AT+MWRESYNC <enter> Immediate
AT+MWSTATUS Get the status of RF AT+MWSTATUS <enter>
Sample Output:
General Status
MAC Address : 00:0F:92:A1:A2:A3
Operation Mode : Master
Network ID : pMDDL
Bandwidth : 8 MHz
Frequency : 5745 MHz
Tx Power : 20 dBm
Encryption Type : AES-128
Traffic Status
Receive Bytes : 0B
Receive Packets : 0
Transmit Bytes : 55.766KB
Transmit Packets : 473
Immediate
AT+MWSNR Get the value of SNR (Slave) AT+MWSNR <enter>
Sample Output:
43
OK
Immediate
AT+MWNOISEFLOOR Get the value of Noise Floor (Slave) AT+MWNOISEFLOOR <enter>
Sample Output:
-99
OK
Immediate
AT+MWSQTHRESH Get/Set Squelch threshold AT+MWSQTHRESH[=<Squelch Threshold>]
Squelch Threshold : -1 to -128 (-1 = Turn off the threshold)
AT&W
AT+MWRSSI Get radio RSSI AT+MWRSSI <enter>
Sample Output:
00:0F:92:FA:59:F9 -74 dBm
Immediate