© Microhard 31
3.0 Hardware Features
3.2.3 pMDDL5824 Development Board / Enclosed Connectors & Indicators
Figure 3-4: pMDDL5824 Development Board
Antennas:
The pMDDL5824 Development Board uses SMA Female connectors, short jumpers are required between
the OEM modules and the Antenna Ports. Ensure proper orientation to prevent damage to the
pMDDL5824 module and to the development board. ANT1 and ANT2 are marked on the pMDDL5824
modules.
Ethernet LAN:
The Ethernet LAN ports are standard RJ45 ports to connect local network devices. The default IP address
for this port is 192.168.168.1.
Ethernet WAN:
The Ethernet WAN port is a standard RJ45 Port that can be used as a separate WAN port for Router
functions, or can be bridged (via software) to the LAN as a additional switch port for local devices.
The pMDDL5824 development board can be powered using Passive PoE from 12—30 VDC Maximum
on the WAN port using a PoE injector that meets the following requirements:
Power:
The pMDDL5824 development board can powered using an input voltage in the 9-30
VDC range.
Ethernet RJ45 Connector Pin Number
Source
Voltage
1 2 3 4 5 6 7 8
12 - 30 Vdc Data Data Data DC+ DC+ Data DC- DC-
Table 3-2: Ethernet (WAN) PoE Connections
To Next Page
Loading...
