Micromeritics GEMINI VII 2390

To Next Page

To Previous Page

9 Installation Checklists

Procedure

Evaluation

Code

Initial / Date

The analyzer has been connected to a power source. P F N/A

Configure the Ethernet port. P F N/A

Connect computer to analyzer. P F N/A

Connect theEthernet switch, if applicable.

n If one Ethernet based analyzer was purchased, connect the

Ethernet cable to the analyzer and the computer, or

n If more than one Ethernet based analyzer was purchased,

connect an Ethernet cable from the computer to the Eth-

ernet switch. Then connect the Ethernet based analyzers to

the Ethernet switch.

P F N/A

Install application software (not for keypad installations). P F N/A

Computer or Keypad Setup

9 - 2

Gemini VII 2390 Installation Instructions and Checklist

239-42870-02 Rev (B) — May 2021

Micromeritics GEMINI VII 2390 - Page 100