7 Operational Verification
CREATE SAMPLE FILES
Options >Option Presentation >Show Degas Conditions
File >New Sample >[.SMP File]
File >Open > [.SMP File]
If using a keypad with the analyzer, skip this topic.
For 21CFR11 environments, this section is applicable only to members of the
Developer group; however, members of the Analyst group may find information in this
section helpful. Sample file information that is available to Analysts is created by a
member in the Developer group using information in this section.
Each analysis must be linked with a sample file before the analysis can proceed. A sample file can
consist of parameter files; however, parameter files can also stand alone.
Specify or change the option presentation by selecting Options > Option Presentation, or use
the view selector drop-down list at the bottom of the window.
Sample files created in the Basic option presentation must be selected from parameter files
created in the Advanced option presentation. The values specified in the parameter portions of the
default method are the defaults for new sample files. To navigate from one set of parameters to
another, select the parameter tab across the top of the window.
The Degas Conditions tab displays only if enabled in Options > Option
Presentation > Show Degas Conditions
7 - 8
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021
To Next Page
Loading...
